Line Lights Are Usually Used Outdoors

May 15, 2020

Since LED line lights are usually used outdoors, the waterproof level is an important parameter of line lights and an important indicator that affects the quality of the guardrail tube. LED line lights must have a waterproof rating higher than IP65, and also require related pressure resistance and shatter resistance. Cracks, high and low temperature resistance, flame retardancy, impact resistance and aging levels can cope with severe outdoor weather.

The traditional waterproof method of LED line lights uses internal glue, and then the wiring and wiring also need to be waterproof. Apply waterproof glue, then seal the plug, and then seal the waterproof glue to a place where water can easily enter. This process is very complicated. After a whole set of processes, the work efficiency is very low, which also affects the appearance. At the same time, during the installation process, please be careful not to damage the waterproof rubber waterproof ring.

The protective layer is a colorless, odorless, transparent, safe, non-toxic, non-flammable, anti-corrosive, salt spray-resistant, waterproof, and moisture-proof liquid that complies with EU environmental standards and has more than 100 test certifications. The coating can penetrate into every tiny gap of the electronic component to achieve complete coverage and wrapping, so that the product can obtain a comprehensive three-dimensional waterproof effect. Even if the light bar is immersed in water, it will not be affected in any way and can work normally.

LED linear lights are assembled with PCB hard boards. LED linear lights are a very simple product. The appearance, structure and functions on the market are almost the same, but the price varies greatly.

LED linear lamp wire requirements: LED circuit board as a light source carrier directly affects the lamp life and failure rate. All electronic circuits of LED lighting products are on the PCB circuit board. Its materials and processing technology directly affect the quality and life of products.

The LED linear lamp housing is made of aluminum alloy material with clear lines, simple structure, beautiful appearance, strong, corrosion-resistant and easy to install. The surface of the lamp is electrostatically sprayed, with high temperature and weather resistance. The reflective plate adopts imported anodized aluminum plate to ensure high energy output. 3MM thick high-strength tempered glass with high light transmittance and impact resistance.

Related News

Product Recommended

  • 8W Trimless Recessed ...
  • 20W IP65 Surface Moun...
  • 30W Linear Pendant Li...